A.18 コンテキストを変更する識別子

\layout や \with ブロック内でコンテキストを変更するのに使用できるコマンドの一覧です。

システムの制約により、以下の一覧は英語での提供となります。

\EnableGregorianDivisiones ¶

Configure division commands such as \section to create Divisio grobs rather than BarLine grobs. This does not affect measure bar lines or the properties of the grobs themselves.

• Sets translator property caesuraTypeTransform to caesura-to-divisio.
• Sets translator property doubleRepeatBarType to '().
• Sets translator property endRepeatBarType to '().
• Sets translator property fineBarType to "".
• Sets translator property sectionBarType to "".
• Sets translator property startRepeatBarType to '().
• Sets translator property underlyingRepeatBarType to "".
• Sets translator property doubleRepeatSegnoBarType to "S-||".
• Sets translator property endRepeatSegnoBarType to "S-||".
• Sets translator property fineSegnoBarType to "S-||".
• Sets translator property fineStartRepeatSegnoBarType to "S-||".
• Sets translator property segnoBarType to "S-||".
• Sets translator property startRepeatSegnoBarType to "S-||".

\RemoveAllEmptyStaves ¶

Remove staves which are considered to be empty according to the list of interfaces set by keepAliveInterfaces, including those in the first system.

• Sets grob property remove-empty in VerticalAxisGroup to #t.
• Sets grob property remove-first in VerticalAxisGroup to #t.

\RemoveEmptyStaves ¶

Remove staves which are considered to be empty according to the list of interfaces set by keepAliveInterfaces.

• Sets grob property remove-empty in VerticalAxisGroup to #t.